Doofor DF550L-BLTG-2M is a hydraulic rock drill equipped with two rotation motors and multiple sealing and hermetic rotation mechanism for demanding underground conditions. Two rotation motors enable continuous, high torque while maintaining high rotation speed. The stainless steel BLT-flushing head can be turned upside down. Motor fitting direction can be specified (up, down or side).
Doofor DF550L-BLTG-2M is a high-frequency hydraulic rock drill specially designed for ground stabilization and general excavations. The drifter has a very low overhead, only 84 mm from the drill center line.
The rock drill has a separated, non-corrosive flushing box. Flushing media can be water, air or grout (limitations apply). The rock drill can be equipped with shank adapters (striker bars) R32, R38, T38, and T45.
Optimal maximum hole diameter for the DF550L is 76 mm.
*) Motor options are 80 cm³, 100 cm³, 125 cm³ and 160 cm³. Number given is for standard rotation motors (2*160 cm³) at an intermittent pressure of 275 bar [3989psi].
**) Number given is for standard rotation motor (2*160cm³) at an operating pressure of 175 bar [2466psi].
The product is for professional use only, as a component of a hydraulic system.
Feed force (pressure) must be adjustable during operation. Rotation torque and oil flow values given are for a typical rotation motor. See full brochure for detailed information on different rotation motors. Percussion pressure mentioned is a recommended value for a typical application. The product is intended for professional use by skilled personnel. Doofor reserves all rights for changes without prior notice.